===== tacks

I didn't recognize my kinky interestes until around 12 or so while
watching the Three Stoges.  They had this one show where they were using
a machine gun loaded with tacks to speed up upholstry work.  Well the
show ends with them machining gunning the tacks into a woman's bottom;)

I've made tack bras before.  Takes some time.  I've been playing with
a new design using nursing pads, its easier, but doesn't have the look
of a tack bra.  On the other hand, Gee thats an interesting pattern on
your jeans ;)

One way of keeping tacks in place would be to push them through the fabric
of one bra, and them put another one over the top, holding them in place.
Just a thought :-).

I've thought of that, but it does require two bras.  It could work ok
as long as you don't look funny wearing them.

I've been thinking about how best to prepare "spiky" bra and panties, and
I think I have a solution.  I believe the best type of tacks to use would
be thumbtacks (or as we call them over here, drawing pins -  a short tack
with a broad smooth head for fastening papers to a drawing board, etc).
If these were pushed through a fairly stiff fabric, say denim, I could
then cut it to the right size and sew it into the cups of a bra, or into
panties.  The head of the thumbtacks would stop them coming out (they'd
be sandwiched between the two fabrics), and when worn, the bra would push
and hold them in place.  This would be ever so easy to do, and from the
outside it would look just like normal bra/panties.  We could even make
pairs of varying "sharpness", for you to use depending on your mood.
It might even be possible to devise some way to heat the tacks when in
place too (but I'll leave that to your deliciously devious mind!).

Nursing pads are stiff enough and meet some requirements.  Denim may be
too thin or the tack may need to be cut back.  If you used a longer pin
and set it so it stick out an inch or so, you could heat the pin from
the outside.  Your bra would look like a porcupine.  The other option
would be to preheat the pins before putting on the bra.

Another option is a product from 3M.  This is a pad about 1/4 inch thick
and in sizes from about 1x2 to 2x6.  These can be found in the same
section as steel wool.  The pads by themselves are rough, add tacks to
make tack pads.

Carpet tacks can be used instead of regular tacks.  They are much sharper
then regular thumb tacks.

The proper length for the tacks is just long enough to stick through the
pads and just stick out a small amout.  The amount can be adjusted for
the effect your want, but its best that it be a little so they don't
penetrate the skin.  Most of the pain and feeling comes from rubbing
against the skin, not penetrating it.  when you penetrate the skin,
there is an initial burst of pain, but then the feeling can apidly go
away until you don't feel the tack anymore.

After suitable sterilization, thumbtacks are placed on a chair and you
get to sit in the chair.  Thumbtacks could also be placed on a table
and you get them pressed into your breasts.